The inner layer of the cable is made of plastic tube. Outside this tube is
there metalrings with a fixed space between them. Each second ring is
connected to the power supply unit as described in the drawing. Outside the
metal rings is there a second plastic tube. The space between the plastic
tubes are filled with a insulating stuff. Outside the second plastic tube are
there a layer of clean wool. Outside this layer are there a third plastictube
who are the cable housing. The first plastic tube (the centre of the cable)
should be approximate 3 Cm in diameter. The total diameter of the cable can be
10 Cm in diameter. The voltage between the metal rings are 50000 Volt
stabilized DC. This is done to make a electric field inside the cable who can
held the energyplain 2 power inside the cable. The cable must be connected in
such a way that the positive metal rings are closest to the energyplain 2
source. The metal the rings are made of can be Copper or Aluminium. One can
experiment to get the most suitable metal. In the centre of the cable one can
try with wool, A gas,Air or Vacuum. Clean wool can be the most favourable
material since wool conducts high energyplain based forces. It maybe increase
the conductivity if it's made like a knited stocking on the inside of the
centre plastic tube. It's possible to connect the metalrings to a resistor
network in order to increase the electric fieldstrength between the metal
rings progressively. This is done if the cable shall be used in teleporter
circuits. This cause a attractive force
to be made inside the cable. This force is used to drag the object who are at
a transmitting state trough the cable to the teleporter antenna. This because
the a clean electrical field can be used to make forces on the etherical
level. The distance between the metalrings inside the cable should be less
than 3 Cm,but not smaller than 1 Cm. The insulating stuff between the rings
can be transformer oil.
