Wednesday, March 3, 2010

TIME MACHINE

This is a device witch enables time travelling. The central part of the
device consists of 2 frame antennas who are arranged 90 degree in
relationship to each other. Each frame are approximately 2 meters in diameter.
The antennas can consist of a tube which are 10 Cm in diameter. The tube must
be superconductive. Inside the tubes floats liquid helium for the
superconductivity. The control device of the machine consists of a sinus
generator with a tuning capacity from 1 Hz to 1000 MHz. The signal form this
generator is amplified a little before it goes to a phase changer. This change
the phase of the signal 90 degree. The phase changer is independent of the
frequency in. The phase change is 90 degrees for both 1 Hz and 1000 MHz input.
The insignal is splitted just before the phase changer so that on part is
unchanged and another part is changed 90 degrees. After the phase changer are
the signal amplified with 2 linear amplifiers to 100000 Watt on each channel.
After that are the two channels feeded to it's respective frame antenna. The
signal on one frame antenna will always be 90 degree in phase difference to
the other frame antenna.

USE: The generator is set to 1 Hz,and the machine is turned on. A compass
needle at the centre of the machine will travel slowly round. Inside and round
the antenna system it becomes a powerful rotating magnetic field. At a higher
generator frequency,the magnetic field will rotate faster. Approximate 2 meter
from the antennas are placed several chairs arranged in a circle around the
antenna system. Her are the timetravellers placed. One increase now the
generator frequency gradually until the speed of the rotating magnetic field
is close to the speed of light. If now the right conditions are present
(etherical/astral),the time will run slower for those who are sitting on the
chairs compared to persons outside the powerfield. Seen from the chairs the
time will run normal between each chair. The timetravellers clock will run
normal. They will see the clock on the wall outside the powerfield running
fast into the future. The nearer the rotating speed of the magnetic field
comes to the light speed,the faster will the timetravellers move into the
future. If the speed of the magnetic field are set equal to light speed,the
time will freeze seen from outside the magnetic field. Seen from the
timetravellers view they are mowing endless fast into the future. ( they will
not be able to sense the world outside the magnetic field and the time will
stop for them). If one increase the frequency further,the rotating speed of
the magnetic field will become greater than the speed of light. The time
sensed from the chairs would then be reversed,and they will see the clock on
the wall outside the magnetic field moving backward. The timetraveller will
now travel back in time. At the speed of light the time travellers goes both
endlessly fast into the future and the past at the same time. The result is
that the time freezes at that speed. At a higher frequency they will travel
slower into the past. When the speed of the magnetic field approaches the
lightspeed from oboe,the timetravellers will travel faster into the past. At
the speed of light for the magnetic field rotation,the time is freezed for the
people inside the powerfield and they can't register anything. For a outside
person who looks inside the powerfield it looks like looking at a freezed
hologram. If one from outside the magnetic field try to touch the field at
this state,it seems harder than steal. The outside person will at this state
not be able to penetrate the powerfield who acts as a endlessly strong armour
at that state. If one put a clock inside the powerfield an outside person
will observe following: At 1 Hz the clock will run normal. When the frequency
arrive the lowest part of the VHF band (oboe 30 MHz) the clock seems to be
going slower. At the top of the VHF band (approximate 300 MHz) the clock will
stop completely. In the lower part of the UHF band (from 400 MHz) the clock
begin to go slowly backwards. At 1000 MHz the clock will go approximately at
normal speed backwards. It's possible that the machine must have a injection
of modulated orgon energy to function.