The principle is the same as a American construction use. The American
construction took the healing energy from a neutronstar in another galaxy.
This construction takes the healing energy from the Sirius-system. The
construction is therefore build different compared to the American
construction. This construction uses a computer. This computer can be a
commodore 64 or another computer capable of generating square wave signals.
The computer generates specific patterns of single frequencies sent sequential
with specific time durations. This will have a positive effect on the chakra
system.The computer calculates the frequency pattern according to the disease.
The 5 Volt signal from the computer runs trough a simple amplifier connected
to a transformer. This transformer transforms the signal up to 4000 Volt
PEP.This signal goes to a highenergy receiver who can receive energies on
higher energyplains. The housing of this receiver is a open pyramid with a
aluminium frame. The bottom of the pyramid is closed. The bottom plate consist
of copper. In this copper plate it's cut a pattern that harmonize with the
energies from the Sirius-system. This cause the receiver to be tuned into the
energies from Sirius. Right above this plate inside the pyramid it's mounted a
blue LED who are modulated with the signal from the computer. This clear blue
LED sends the blue energies into a clear mountain crystal of super quality.
This crystal is mounted vertically inside the pyramid, just over the LED.
Around the bottom part of this crystal there are a coil with 4 or 5 turns.
This coil is made of copper wire who are 1mm in diameter. Higher up on the
crystal there are a infrared LED mounted. This LED are placed 90 degrees
according to the crystal,and the energy from this LED are sent horizontally,
pointed at the centre of the crystal. The purpose of this LED is to eliminate
negative energies from the patient. The IR LED can either be on continuously
or be modulated from the computer. When the blue LED is on ,the crystal is
synchronised with energies from the Sirius-system. The sirian energies are
transformed in such a way that they are mixed with the frequencies in the
coil. This cause the signal from the computer to be influenced by energyplain
2 and 3 frequencies. A wire from this coil goes to a treatment probe the
patient shall hold in his hand. Inside the treatment probe the wire goes via a
quartz burner before it reach the main circuit inside the probe. This main
circuit consist of a geometrical system of GEM stones inside a quartz tube.
The gemstones are surrounded by sea water. In the middle inside this quartz
tube there are a mountain crystal who are surrounded by a Tesla coil. The
Tesla coil is made of very thin copper wire. At the end of this coil there
are a lid who have a spiral coil on one of it's sides. In the middle of the
spiral coil there are mounted a special crystal who harmonizes with the sirian
energies. Inside the quartz tube the GEM stones are glued to the outside of
the Tesla coil surrounding the crystal. This GEM stones are placed after a
specific pattern. The Tesla coil and the spiral coil are daisy chained. This
coil system have a impedance of 8 Ohm. The coilsystem are connected to a
adioamplifier who deliver 10 Watt. This amplifier gets the signal from the
computer. At general treatments the signal to this coil system is turned off.
By specific treatments the probe tip are aimed at the problem area,and the
signal to the coilsystem must be on. The quartz burner treat the signal in
such a way that it activates the GEM stones at a higher engonic level.
Several over harmonics are also generated. The light from the quartz burner
amplifies the higher engonic fields in the probe. At audiodiagnostic of the
aura,the signal must bypass the quartz burner and the blue led in the receiver
unit must be off. This disables the engonic field who could disturb the
diagnostic process. In treatment mode the blue LED in the receiver and the
quartz burner must be on in order to process the sirian energies for
treatment purposes.
